Not so much customizing, but repair. I figured customizers would know lots of stuff. [img]wink.gif[/img]
I just had a peg break off in a joint. I tried drilling it out, but obviously that just makes the peg spin. How would you guys suggest I get it out?
<font size="2" face="Verdana, Helvetica, sans-serif">take a small nail, drive it in to the post, then boil the part and pull the stufk part outOriginally posted by Peter Hoffman:
Not so much customizing, but repair. I figured customizers would know lots of stuff. [img]wink.gif[/img]
I just had a peg break off in a joint. I tried drilling it out, but obviously that just makes the peg spin. How would you guys suggest I get it out?
that or a tiny screw, into the peg, and pliers to pull.
That may have worked, but now the peg is mangled with a hole in it. Perhaps I'll give it a try with a screw.
I've had no luck with those situations.
I've ended up leaving the stuck pegs in the holes. [img]frown.gif[/img]
a screw will do...
hmm... [img]wink.gif[/img]
Bah, my drilling attempt ruined any chance of getting it out. Now there's a hole and the screws just rip right out.
I just used some white glue and put the things head back on. (Grid Alien)
I hope CS comes through, but I highly doubt they will.
mini-torch [img]biggrin.gif[/img]
I melt everything that pisses me off [img]wink.gif[/img]
it'll either soften it enough to pull it out, or melt it right into the body! [img]wink.gif[/img]
bend a safety pin so it has a VERY small hook on the end.
go fishing.
I've done this.
it will work.
big pain in the ass, though.
I will keep all your suggestions in mind. Thank you.
Posting Permissions
Bookmarks